Autosoft Journal

Online Manuscript Access


Study of Shearing Line Traces Laser Detection system


Authors



Abstract

A set of laser detection system for shearing tools is developed, By holding breakage of the cable, firstly, using single-point laser displacement sensors to pick up surface features signal of line trace, then wavelet decomposition is used to reduce the noise, and the signal after noise reduction is obtained. After that, the threshold based sequence comparison method is used to achieve matches of similar coincidence for trace features, and then using a gradient descent method to getting the minimum cost of cost function value through continuous iterative, and finally realizing the fast traceability of corresponding shearing tool.


Keywords


Pages

Total Pages: 7

DOI
10.31209/2019.100000098


Manuscript ViewPdf Subscription required to access this document

Obtain access this manuscript in one of the following ways


Already subscribed?

Need information on obtaining a subscription? Personal and institutional subscriptions are available.

Already an author? Have access via email address?


Published

Online Article

JOURNAL INFORMATION


ISSN PRINT: 1079-8587
ISSN ONLINE: 2326-005X
DOI PREFIX: 10.31209
10.1080/10798587 with T&F
IMPACT FACTOR: 0.652 (2017/2018)
Journal: 1995-Present




CONTACT INFORMATION


TSI Press
18015 Bullis Hill
San Antonio, TX 78258 USA
PH: 210 479 1022
FAX: 210 479 1048
EMAIL: tsiepress@gmail.com
WEB: http://www.wacong.org/tsi/